I used the thaiphoon program and scanned my ram and it turned out they have crc error in a sector that that somehow controles the lights.Īnd each time i was scanning the ram i got different crc error
Software crashed.ram lights dont respond.ect. The ram works fine but when it comes to the RGB lights and the software, then all hell is loose. Like my self and others that have problems with with the trident z RGN serie and the softwares Trident z RGB or asus aura that also controles the lights on the ram.basicly these 2 programs looks like the same and i think they are the same. In bios i cant see any ram either installed in this slot.how do i know what slot 1 and smbus 52h is ?ĭont tell me my motherboard ram port is messed up or broken ! Totaly bummed out here.I just wish i had 32 gb ram and will live happy with the rainbow inbuild now Slot # 3 shows ddr4 G skill F4-3200C14 -8gtzrīut i can still read the ram in thaiphoon it shows 50 h 51 h 52 h 53h Slot # 2 shows ddr 4 G skill but f4-3200c Slot# 1 shows ddr4 G skill F4-3200C14 -8gtzr Then i tryed to flash all the ram again from 00h to FFH and now i have this messed up system that shows 16 gb ram even if i have all 4 ram block installed for 32 gb. Then i installed asus aura and i could use all the light features.even the comet worked like a charm.then i rebooted all hell was back again.every crc error. Then i flashed all the ram again from 00h to ffh and then it almost worked.there was only 1 ram block that had 1 crc error with a single hex that was set to FF and not 00. So i uninstalled asus aura and installed G skill newest RGB Software and followed the unsinstall leting the folders in programs also, and then i used CCleaner to make sure bits and bumps was gona be clearned up. Then i tryed to read and write all the rams again and then i got differents crc error each time i scanned.that could be something software related that was messing up my ram. Then i was still stuck with the same error code we see in the guide refering to the light area in the ram hex. Then i took out the power cable and reset the power in order to make the ram hex normal again. First time i flashed then i used lower end only like in the guide and that dident work.then i tryed manualy to compare the hex and i changed all the numbers that was messing up.that resulted in alot of FF in the hex scan and the ram became unknown in the info.
0 kommentar(er)
